Lantronix XPress DR+ Manual do Utilizador descarregar pdf (Página 19)

Chapter 3: Installation and Hardware

XPress DR+ User Guide 19

Figure 3-1. Typical Configuration

1. Connect a serial device to your XPress DR+. (See Serial Interface on page 20 for

cable and connector specifications.)

2. Connect an Ethernet cable to the Ethernet port. (See Ethernet Interface on page 23.)

3. Supply power to your XPress DR+ using a 9-30 VDC or 9-24 VAC (2.3W maximum)

source. (See Power Requirements on page 24.)

4. Supply power to the serial device.

Note: Connecting a device to an active Ethernet network can disrupt

communications on the network. Make sure the device is configured for your

application before connecting it to an active network

XPress DR+ Front Panel

The following figure illustrates the screw block connector pinouts and other components

of the XPress DR+.

Note: For a description of the XPress DR+W front panel, see Chapter 4: XPress

DR+W.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 115 116

Sem comentários

Lantronix XPress DR+ Manual do Utilizador Página 19