Lantronix A104 Manual do Utilizador

Model Name: A104 (For Conexant Chipset)Version: 1.0FCC Part 68FCC Part 15Chapter 1. IntroductionChapter 1.1 OverviewChapter 1.2 FeaturesChapter 1.3 Sy

The POTS splitter may also be installed on the outside of thehouse adjacent to the telephone network interface device (NID).(ADSL over ISDN)A ISDN spl

The ISDN splitter may also be installed on the outside of thehouse adjacent to the telephone network interface device (NID).Before you configure the r

Gather the information as illustrated in the following table and keep it forreference.VPI/VCI, Service Name, Username, Password, and Domain Name Syste

LAN and VPI/VCI of WAN. Then save and reboot Router, it will workfine with your whole system. The computer should be set the fixedassigned IP address

If you want to configure the device with administrator level, type in theusername field and in the password field. If you want to configure

The Home page shows the firmware versions and WAN and LAN interfacestatus.This field display the Conexant firm ware(vxworks.z) version number.This fie

The page shows the ADSL physical layer status.This field displays the Conexant ADSLdata pump firmware version number.This field displays the ADSL conn

This field displays the time of the modem has been inoperation.Amount of increased noise that can be tolerated whilemaintaining the designed BER (bit

These fields display the IP address, Subnet Mask and MACaddress for the LAN interface.This field displays the total numberof available interfaces for

These fields display the Connection Name (user defined),Interface (PVC), Mode (PPPoE or PPPoA), Status (Connected or NotConnected), Packets Sent, Pack

Chapter 3.3.14 Admin Privilege - WAN StatusChapter 3.3.15 Admin Privilege - ATM StatusChapter 3.3.16 Admin Privilege - TCP StatusChapter 3.3.17 Admin

To switch between the PVCs, please choose the options ofvirtual circuit and click on the button to switch over.The is developed to solve the scenario

The current release supports multiple PPP sessions per PVC.The PPP configuration in the WAN configuration page is for thefirst PPP session for each PV

When it is checked, it will maintain the PPPconnection all the time. If the ISP shut down the PPP connection, it willautomatically reconnect PPP sessi

PVCGeneral MulticastIP- IgnoreThe configuration page allows the user to set the configuration for theLAN port.The default is 10.0.0.2 and255.0.0.0. Us

The configuration page allows the user to set the LANport into Auto Sense, 100 Mbps Full Duplex, 100 Mbps Half Duplex, 10Mbps Full Duplex or 10 Mbps H

This field allows the user to enter his/her own sessionName to distinguish different session for different PPP accounts anddifferent PVCs.This field a

of the PPP connection will be set to the smaller one of MTU and thepeer’s MRU. The default is value 1492.Maximum Segment Size is the largest size of d

This field allows the user to enter his/her own account IDto distinguish different accounts.Enter the PPP user name (usually provided buy the ISP).Ent

Network Address Translation capability between LAN and multiple WANconnections, and the LAN traffic is routed to appropriate WAN connectionsbased on t

show the corresponding Session Name with its IP address.This filed displays the total numberof NAT Sessions is entered.will be displayed at the end of

advance. But if advance notice isn't practical, you will be notified as soon aspossible. You will be advised of your right to file a complaint wi

page to show all the NAT Session Names with its WAN Interface.This filed displays the total numberof NAT Sessions Name is entered.Click the link to th

This field allows the user to enter the port number of thePrivate Network. In most cases, the private port number is same aspublic port number.This fi

The DNS proxy will storethe DNS server IP addresses obtained from DHCP client or PPP intothe table. And all DNS query messages will be sent to one of

be filtered out. If the is selected, then the packets will beforwarded to the destination PC.When the bridge filtering is enabled, enter, select and c

rebooted. Please wait….”After the Save and Reboot, the following Web page will bedisplayed “Your setting have been saved and the modem hasrebooted.”Th

These fields display the IP address, Subnet Mask and MACaddress for the WAN (ADSL) interface.This field allows the user to release andrenew the WAN IP

: This button allows user to reset the ATM Statuscounter.The page shows the statistics for all TCP connections.

: This button allows user to reset the TCP Statuscounter.The page displays routing table and allows the user to manuallyenter the routing entry. The r

The Gateway field of the static route entry allows users to either enter aGateway IP address or select a Network Interface.All user-defined routes ret

Network Interface, then that Gateway’s IP address appears in theGateway field of the route entryIf the selected Network Interface is dynamic but the c

Changes or modifications not expressly approved by the party responsible forcompliance to the FCC Rules could void the user's authority to operat

This field allows the user to enter the update periodfor the MAC table.The page allows the user to set the configuration forADSL protocols.

This field allows the user to enable or disable the Trellis Code.By default, it is always enabled.This field allows the user to select the ADSLhandsha

This field allows the user to Enable or Disable the RIP session.The resulting RIP session will monitor all network interfaces that arecurrently availa

This field allows the user to choose the Interface (PVCs,PPP Sessions, USB and LAN), for the RIP to be configured.This field allows the user to Enable

status.The page allows the user to set thepassword for administrator.The Admin password is same pas the FTP password, so it musthas at least 8-charact

The allows the user to set all themiscellaneous configurations.

This field allows the user to configure the Webpages can be accessed from.When this field is checked, it allows both WAN and LAN access tothe Web page

The IP address of the DMZ host at LAN side.If it is enabled, the DHCP requests from local PCs willforward to the DHCP server runs on WAN side. To have

The page shows the test results for the connectivity of thephysical layer and protocol layer for both LAN and WAN sides.

This test checks the EthernetLAN interface connection.This test checks the ADSL showtime.If this test returns FAIL, all other tests will be skipped.Th

The CX82310 is built upon a scalable architecture and is fully compliant withfull-rate ADSL (T1.413 Issue 2 and G.dmt standards) and the splitterlessG

This test checks the PPP authentication.This test checks a valid IP address assignedfrom the service provider.This test checks the primary DNS can be

The page allows the user to upgrade theimage code from the remote FTP server.Assume an FTP server stores the updated image firmware.dlf on Internet.Cl

The page shows the events triggered by the system.

This field allows the user to clear the current contents ofthe System Log.This field allows the user to save the current contents of theSystem Log by

Characteristic of any network multiplexes independent network carriers onto asingle cable. Broadband technology allows several networks to coexist on

physical layer, followed by a header from the network layer (IP), followed by aheader from the transport layer (TCP), followed by the application prot

use individual addresses responsibly. Each address is a 32-bit address in theform of x.x.x.x where x is an eight- bit number from 0 to 255. There are

Plain Old Telephone Service - This is the term used to describe basictelephone service.Point-to-Point-Protocol - The successor to SLIP, PPP provides r

Routers periodically exchange information with one another so that they candetermine minimum distance paths between sources and destinations.Simple Ne

For routing purposes, IP networks can be divided into logical subnets by usinga subnet mask. Values below those of the mask are valid addresses on the

- Tone detection for low power mode- Supports splitter less ADSL implementation- Supports Dying Gasp- Interoperable with all major DSLAM equipmentATM

that delivers packets in sequence, as happens on an actual point-to-pointnetwork. In reality, the data is delivered across a network via the mostappro

To check LEDs light up when you finish connecting two pieces of hardware.This declaration of conformity is according to article 7(3) and article 10(2)

and satisfies all the technical regulations applicable to the product within thescopeof Council Directives 91/263/EEC and 93/97/EEC: TBR21The equipmen

- WAN and LAN side connection statistics- Configuration of static routes and routing table- Password protected access- Selection of bridge or router m

ONOFFModem is powered ONModem is powered OFFFlashing When the router is working properlyONFlashingOFF"Showtime"-successful connection betwee

modem and the ADSL network through a twisted-pair phone wireThis section describes how to connect and configure the ADSL router.Connect the router dir