Lantronix Computer Hardware 900-581 Manual do Utilizador descarregar pdf (Página 13)

3: Command Line Interface

PremierWave EN Command Reference 13

Note: >To configure the PremierWave EN, you must be in the enable level and any of its

sub-levels. Figure 3-4 below shows the enable level commands.

Figure 3-4 Enable Level Commands

>enable

(enable)#?

auto show interfaces auto show processes

clrscrn configure

connect connect line <line>

cpm device

disable dns

email <number> exit

filesystem kill ssh <session>

kill telnet <session> line <line>

ping <host> ping <host> <count>

ping <host> <count> <timeout> reload

reload factory defaults show

show history show interfaces

show ip sockets show lines

show processes show sessions

ssh ssh <optClientUsername> <host>

ssh <optClientUsername> <host> <port> ssl

telnet <host> telnet <host> <port>

trace route <host> tunnel <line>

write xml

<enable>#

See the Chapter 5: Commands and Levels at the end of this document for a complete list of levels,

commands, and descriptions.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 211 212

Sem comentários

Lantronix Computer Hardware 900-581 Manual do Utilizador Página 13