
8: Line and Tunnel Settings
EDS1100/2100 User Guide 55
UDP (available only in Connect Mode because it is a connectionless protocol).
Telnet
Note: The Local Port in Connect Mode is independent of the port configured in Accept
Mode.
Connect Mode has six modes used to initiate and maintain a connection:
Disabled (no connection)
Enabled (always makes a connection)
Active if it sees any character from the serial port
Active if it sees a specific (configurable) character from the serial port
Modem control signal
Modem emulation
To configure Tunnel 1 Connect Mode, perform the following steps.
1. Select Tunnel 1 > Connect Mode. Figure 8-16 shows the page that displays.
Figure 8-16 Tunnel Connect Mode Page
Comentários a estes Manuais