Lantronix EDS1100 Guia do Utilizador descarregar pdf (Página 24)

3: Installation of EDS1100

EDS1100/2100 User Guide 23

Figure 3-6 EDS1100 Top LEDs

Installing the EDS1100

Be sure to place the device on a flat horizontal or vertical surface. The device comes with

mounting brackets for mounting the device vertically, for example on a wall. If using AC power,

avoid outlets controlled by a wall switch.

Observe the following guidelines when connecting the serial devices:

 The EDS1100 serial ports support RS-232/422/485 devices.

 The null modem cable is the best cable to connect the serial port to a DCE device. The

straight-though (modem) cable is the best cable to connect the serial port to a DTE device.

 Power-up the device by using the barrel-power connector only. The barrel-power connector

supports a power range of 9 to 30 VDC.

Note: As soon as you plug the device into power, the device powers up automatically,

the self-test begins, and Evolution OS™ starts.

Perform the following steps to install your device. The steps are shown in Figure 3-7.

1. Connect a serial device to your unit.

Table 3-1 EDS1100 LEDs and Descriptions

LED Description

Power (blue) ON—EDS is receiving power

TX Serial (green) Blinking—EDS is transmitting data on the serial port

RX Serial (yellow) Blinking—EDS is receiving data on the serial port

Diagnostic ON—EDS firmware has completed booting

Blinking 1x/sec—EDS firmware is booting

Blinking 2x/sec—EDS is writing a file to flash

Blinking 4x/sec—EDS is compacting the file system

Blinking 5x/sec—EDS is restoring factory defaults

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 156 157

Sem comentários

Lantronix EDS1100 Guia do Utilizador Página 24