Lantronix SCS1620 Guia do Utilizador descarregar pdf (Página 35)

SCSxx05/SCSxx20 User Guide 2: Installation

2-5

Connecting the Network Port

The SCS’s network port (10Base-T/100Base-TX) allows remote access to the

attached devices and the system administrative functions.

You must first set up the network parameters for the network port before you can

reach the SCS remotely. You can change the network parameters from the front

panel of the SCS, or you may Telnet to the default address. Refer to the Quick

Start chapter for instructions.

Connecting the Modem Port (SCSxx20)

An optional modem module is available for the SCSxx20. The modem may be

installed at the factory or can be ordered separately for later installation.

Caution: When installing or removing a modem, be extremely careful to avoid

contact with interior components. Contact could cause a short, resulting in fire or

electric shock.

Figure 2-6. SCS1620 Modem Module

The SCSxx20 modem is an analog modem supporting connection rates up to

38,400 baud. The modem has a single RJ11-type analog telephone jack plus five

status LEDs. The user interface to the modem is identical to that found on the

terminal port or the network port. The modem is configured as device port 19 on

the SCS1620 and device port 11 on the SCS820.

The default communication parameters for the modem port are:

 38400 baud

 8 data bits

 1 stop bit

 No parity

 RTS/CTS flow control

You initially configure the modem using the system’s setup program (see

Configuration). If you are installing a modem into a working SCSxx20 system,

refer to the Commands chapter.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 140 141

Sem comentários

Lantronix SCS1620 Guia do Utilizador Página 35