Lantronix UDS100 Manual do Utilizador descarregar pdf (Página 23)

UDS10/UDS100 User Guide Configuring the UDS Using Telnet or the Serial Port

Figure 5-2. Setup Mode

3. Select an option on the Change Setup menu by entering the number of the

option in the Your choice ? prompt and pressing Enter.

4. To enter a value for a parameter, type the value and press Enter. To confirm a

current value, just press Enter.

5. When you are finished, save the new configurations (option 9). The unit reboots.

Using the Serial Port

For local configuration, connect a terminal or a PC running a terminal emulation

program to the unit’s serial port (channel 1). Configure the terminal (or emulation) for

9600 baud, 8-bit, no parity, one stop bit, and no flow control.

1. Cycle the unit’s power (power off and back on). After power-up, the self-test

begins and the diagnostic and status LEDs start blinking.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 77 78

Sem comentários

Lantronix UDS100 Manual do Utilizador Página 23